Shipping And Installation; Safety Warnings For Transportation And Installation - Ravelli HR EVØ 250 SMART Bedienungs- Und Wartungshandbuch

EN
Rev.1 08/09/2021
Pag.22

SHIPPING AND INSTALLATION

Safety warnings for transportation and installation

��
The appliance must be installed by a qualified technician, who must issue a declaration of conformity of the system to the
purchaser, taking full responsibility for appliance installation and correct operation.
��
The appliance installation site must be chosen so that the generated heat can spread evenly throughout the rooms that you
⚠
wish to heat.
⚠
During transport and storage, avoid exposure to rain or persistent humidity.
The appliance needs to be connected to a single chimney that guarantees the draught declared by the Manufacturer and
⚠
observes the installation regulations that apply to the installation site.
⚠
The room where the appliance is installed must have an air intake.
The air vent must be installed in such a way that it can not be blocked.
The Manufacturer will not be held liable for installation that is not compliant with the laws in force, incorrect air circulation in the rooms
and inappropriate use of the appliance.
In particular, it is necessary:
•
that the appliance be connected to a smoke evacuation system duly sized to guarantee the draught declared by the Manufacturer,
that is tight and observes the distances from flammable materials;
•
that there is a suitable combustion air intake in compliance with the type of installed product;
•
that other installed combustion appliances or devices do not create a vacuum in the room where the appliance is installed;
•
that the safety distances from flammable materials are observed.
Verification of system compatibility has a priority over any other assembly or installation operation.
��
Local administrative regulations and particular requirements of the authorities pertaining to the installation of combustion
appliances, the air intake and the smoke evacuation system, may vary based on region or nation. Check with your local
authorities if there are stricter laws than set forth herein.
Packaging
When the appliance arrives, check:
•
that it is the model you ordered;
•
that it has not been damaged during shipping.
⚠
Any complaints must be reported to the deliveryman (also on the delivery note) upon receival.
Check the capacity of the floor before handling and positioning the appliance.
To handle the appliance in its packaging, follow the procedure below:
1 Position the pallet truck forks in the slots under the wooden pallet.
2 Lift slowly.
⚠
3 Place the appliance near the chosen location for installation.
The appliance always needs to be handled vertically. Take extra care to protect the door and its glass against mechanical
impact that could jeopardise their integrity
To unpack the appliance, follow the procedure described below:
1 Cut the straps and remove the wooden reinforcement frame resting on the box
2 Slowly lift the cardboard box
3 Remove any bubble-wrap or similar
4 Remove the appliance from the pallet and position the appliance in the chosen location, ensuring that it is compliant
with the directions.
If the appliance is packed in a wooden cage, replace steps 1 and 2 of the previous table with the steps described below:
1 Remove the side straps by unscrewing the fixing screws
2 Remove the upper and side wooden cage
Use and maintenance manual HR EVO Smart