Tracer Splash M BT TWS Bedienungsanleitung Seite 10

EN
Tracer Splash M BT TWS
cally. You will hear indication voice "Dong" around 3 seconds later. It means TWS
funcion set-up successfully. If want to cancel or set-up TWS function again, just keep
pressing the Play/Pause button 3 seconds.
Charging
1. Plug the USB cable into the speaker connect to the 5V charger or computer to
charge the speaker.
2 . When charging, the "charging" red indicator light on when it is full the red light is
out.
Other
1. The default volume of the speaker is 2/3 of the total volume .To protect battery
life and speakers work, so the software Settings when the battery voltage is low-
er than 3.3 V speakers will automatically detect the concurrent give out sound
prompt alarm, when battery voltage is lower than 3.3 V the speaker makes a voice
prompt and set up automatic shutdown meantime.
2. When the speaker standstill, the speaker will power off automatically if not use
the speaker 10 minutes. If need play again ,needs to power on the speaker again.
Specification parameters:
1. Bluetooth Version: V5.0
2. Bluetooth Range: 10 meters
3. Output power: RMS 10W (5W*2)
4. Driver Size: 40 mm * 2pcs
5. Frequency response: 100 Hz-20 KHZ
6. Built-in battery: 1000 mAh / 3.7V
7. Sensitivity: 75±2 dB
8. Signal to noise ratio: ≥65 dB
9. Distortion: 1%
10. Charge time: 2.5-3.5H
11. Waterproof IPX6
12. Function: Hands-free call/U-disk /AUX /BLUETOOTH/ TWS Function
13. Product size:80*80*95mm
10
Instructions for use