RECARO EXO Bedienungsanleitung Seite 7

3. INSTALLING AND REMOVING
3.1 P ush the neck rest to the lowest position.
3.2 P lace the holding plate on the arched gap in the backrest of your RECARO Exo and push
the holding plate in. Then press the neck rest fi rmly into the backrest to complete full
c ontact between neck rest and backrest.
3.3 S elect the ideal support zone for you by moving the neck rest up or down.
3.4 For disassembly, push the neck rest to the highest position. To remove the neck rest from
the backrest, grasp it with both hands and pull it slowly upwards and out.
3.1
Installing position
4. CHANGE STANDARD/TURNED POSITION
4.1 Push the holding plate on the back of the neck rest to the lowest position.
4.2 Push the upper operating button inwards and move the holding plate down at the same
time. The holding plate is now released from the neck support.
4.3 Turn the holding plate by 180°.
4.4 Insert the holding plate into the guide rail of the foam plate again.
4.5 To change from the turned position to the standard position repeat steps 4.1 to 4.5
4.1 4.2
Lowest position Lowest position
Lowest position
3.2
4.3
Upper Upper
operating button
Upper Upper
operating button operating button
3.3
4.4
180°
180°
3.4
Highest position
7