Maintenance / Cleaning - Acre Carbon Overland Schnellstartanleitung

1. Adjust the brake with a 3 mm Allen wrench. Insert the Allen wrench into the adjustment screw
through the hole in the front of the brake unit.
2. The brake is tightened by turning the adjustment screw clockwise (viewed from the front) and
loosened by turning it counter-clockwise (viewed from the front).
Curb lifter
Even though Carbon Overland is one of the world's lightest rollator and therefore is easy to lift, it is
equipped with a curb lifter that makes it easier to get over smaller obstacles like curbs and low steps.
This is particularly helpful if heavy objects are transported in a front-mounted basket or bag.
1-2.
the ground.
Be aware that the stability of Carbon Overland changes when it is reclined. Be cautious and try
to bypass rather than climb high obstacles.
Accessories
Carbon Overland can be made even more useful with original accessories. A full display of our range
can be found at www.byacre.com.
Never use non-original accessories with the rollator, as this could pose a potential risk for your
safety.
Maintenance & cleaning
Carbon Overland should be regularly maintained by removing dust and dirt. Pay special attention to
keeping the brakes and wheel hub clean.
detergent. Wipe with a dry cloth afterwards. Do not use paper towels as these can scratch the
surfaces.
It may be necessary to occasionally tighten one or more screws with a T25 or a H3 key.
Parts subject to wear such as wheels and brakes should be replaced in good time before they may
pose a safety risk. Any defective part must be replaced immediately.
7