2Addition - Expanding An Existing Plc Network By Adding Another Devolo Magic 2 Wifi - Devolo Magic 2 WiFi 6 Handbuch

3.3.2Addition – Expanding an existing
PLC network by adding another
devolo Magic 2 WiFi 6
Before you can use the devolo Magic 2 WiFi 6 in
your devolo Magic network, first you have to
connect it to your existing devolo Magic adapters
as a network. This is accomplished by using a sha-
red password.
Plug the devolo Magic 2 WiFi 6
1
available power socket. As soon as the LED
flashes white at
0.5 seconds, the adapter is ready to operate
but not yet integrated into a devolo Magic
network (see Chapter 2.4.1 Reading the PLC
indicator light).
Within 3 minutes, press the PLC button on a
2
devolo Magic adapter
devolo Magic network for approximately 1 sec.
The new devolo Magic adapter pairs auto-
matically so no button needs to be pressed.
The LED of this adapter now also flashes
white.
If the LEDs light up white on both
devolo Magic adapters, the new adapter
has been successfully integrated into your
existing devolo Magic network.
into an
regular intervals of
in your existing
For each pairing operation, only one addi-
tional adapter can be added at a time.
3.3.3 Changing the network password
A network password can also be changed in the
following ways:
Using the web interface of the devolo Magic
b
adapter (see Chapter 4.5 Powerline)
or
Using devolo Cockpit
b
devolo Home Network App. For more infor-
mation, refer to the chapter. 3.4 Installation of
devolo software
3.3.4 Establish a Wi-Fi connection with
the devolo Magic adapter
Establish the Wi-Fi connection with your laptop,
tablet or smartphone by entering the previously
noted WiFi key as the network security key.
Integrate the Wi-Fi adapter into an existing Wi-
Fi network
To ensure that the devolo Magic 2 WiFi next has
the same Wi-Fi configuration as your Wi-Fi router,
you can apply the Wi-Fi access data at the touch of
a button using the WiFi Clone function. This can
be enabled in different ways:
Initial use 28
or the
devolo Magic 2 WiFi 6