Troubleshooting; Recycling And Disposal; Manufacturer's Warranty - comfortel presto Bedienungsanleitung

FAILURE TO OPERATE
In the unlikely event that your Comfortel product does not operate correctly,
check that the Comfortel product and mains power supply are switched on,
and that power is available.
The Comfortel Presto has a fail-safe mode that will automatically turn off the unit
as a precaution. In most instances, the following troubleshooting will cover
failure to operate.
TROUBLE SHOOTING
Rotating Brush Automatically Stops.
Pushing down too hard on the rotating brush will cause the brush to automatically
stop as a safety precaution. Please remove brush and wait for the rotating brush
to start again.
Comfortel Presto will not start after installing the cannister.
If the canister is not fully installed correctly, the Comfortel presto will not start.
Make sure the cannister slides all the way into the main unit, and clicks into place.
If in doubt or for further advice, please contact your local distributor where you
purchased this Comfortel product or view our troubleshooting videos at
www.comfortelpresto.com.

RECYCLING AND DISPOSAL

Your Comfortel electrical product is classified as 'electrical or electronic
equipment' and must not be disposed of with other household or commercial
waste at the end of its working life. When you have no further use for your
Comfortel product, please dispose of it according you your local authority's
recycling procedure. For more information contact your local authority.
EN 8
LOOKING AFTER YOUR COMFORTEL PRESTO
• Do not carry out any maintenance or repair work other than shown in this
Operating Manual or advised by your local distributor and/or manufacturer.
• Always disconnect the plug from the mains before inspecting for problems.
If the appliance will not operate, first check the mains socket has electricity
supply and that the plug is properly inserted into the socket.
• A periodic inspection of all components and fasteners should be made to ensure
that your Comfortel product is structurally intact and functioning properly.
MANUFACTURERS WARRANTY
All Comfortel electrical products are individually tested before leaving the factory.
However in the unlikely event of the product proving defective due to faulty
workmanship or materials, then, at its sole discretion, Comfortel will repair or
replace the product at no charge with an identical or equivalent product within
one year from the original date of purchase. A replacement product assumes the
remaining warranty of the original product purchased.
To claim under this warranty, please contact your local distributor, where you
purchased this Comfortel Product. Please ensure that you include a proof of
purchase with any returned product.
This Warranty only applies to genuine Comfortel products purchased through a
Comfortel approved stockists and does not cover products repaired or serviced
by anyone other than Comfortel personnel or Comfortel representatives.
Warranty Claims does not include:
1. Damage caused by misuse, improper treatment or violent usage.
2. Damage caused by failure to comply with these instructions..
3. Damage caused by connecting this appliance to the incorrect voltage.
4. Damage caused by connecting accessories supplied by other manufacturers.
5. Minor faults which do not significantly affect the value of the device or its
effective use.
6. Normal wear and tear.
Note that this Warranty may be invalidated where serial numbers or identification
have been erased, damaged or modified. This does not affect your statutory rights.
For customers in Australia, New Zealand and Singapore, please phone your
nearest Comfortel Showroom. For locations, please visit our website.
owners manual
9 EN