Maintenance; Troubleshooting - Greencut ATD200L Betriebsanleitung

48

MAINTENANCE

Good maintenance will extend the life of the machine. Prolonged or constant use may require more intensive
maintenance for the machine to continue to function properly.
ATTENTION: Make sure the engine is completely shut down before performing any maintenance
or repair. This will eliminate any potential risk.
• Use a damp cloth with water and some mild soap to clean the tool. Never allow liquids to get inside.
• Do not allow dust and dirt to enter the ventilation outlets.
• Do not use solvent substances that can damage the plastic parts.
• It is not necessary to grease the drill.

TROUBLESHOOTING

The table includes some of the most common problems, their causes and remedies.
PROBLEM
Screwdriver does • The battery is not properly installed.
not turn on
• The battery is not charged.
• The battery is not properly inserted
Battery does not
• The charger is not plugged in.
charge
• Ambient temperature is too hot or
• The battery has reached the
The screwdriver
suddenly turns off
• No more load.
NOTE: If you are unable to resolve the problem, please contact the Official Technical Service.
POSSIBLE CAUSE
into the charger.
too cold.
maximum thermal limit.
SOLUTION
• Insert the battery again.
• Check battery charging requirements.
• Connect the battery to the charger until the
red light is on.
• Plug the charger into a working outlet.
• Move the charger and battery to an
ambient temperature above 4.5°C or below
40.5°C.
• Wait for the battery to cool down.
• Put it in the charger and charge it.