Assembly; Product Use - Greencut ATD200L Betriebsanleitung

46

ASSEMBLY

INSTALLATION OR REMOVAL
1. To install the tip, pull the chuck forward and insert the screwdriver tip (8)
or socket bit into the chuck as far as possible. Then release the chuck to fix
the tip or drill bit.
2. Only use screwdriver bits with ballpoint pen (DIN 3126-E6.3). Other bits can
be used with a universal chuck (10).
3. To remove the screwdriver tip or socket drill, pull the chuck (2) forward and
pull the insertion tool firmly.

PRODUCT USE

DIRECTION OF ROTATION
The direction of rotation switch (3) is used to reverse the direction of machine rotation. However, this is not possible
if the on/off switch (4) is activated.
1. Right-hand rotation: To insert screws and tighten nuts, press the direction of rotation switch (3) as far as
the left-hand stop.
2. Left-hand rotation: To loosen and unscrew screws and nuts, press the direction of rotation switch (3) as far
as the right-hand stop.
SWITCHING ON AND OFF
ATTENTION: Tighten the screw in the tool first before operating.
3. To start the machine, press and hold the On/Off switch (4).
4. To stop the machine, release the On/Off switch (4).
SPEED ADJUSTMENT
The speed of the powered tool on can be variably adjusted, depending on how much the on/off switch (4) is pressed.
Slight pressure on the on/off switch (4) results in a low rotation speed. Higher pressure on the switch results in an
increase in speed.