Recycling Information - Hama SMART Bedienungsanleitung

4. Batteries
Initial start-up:
• Before using the product for the rst time, open the battery compartment through
a twisting motion, and remove the contact breaker.
• Then close the compartment. (A)
Replacing the battery:
• Remove and dispose of any used batteries. Insert the new battery (LR44).
• Ensure that the polarity of the battery corresponds to the symbols in the battery
compartment. (A)
Connection to a smartphone, laptop or tablet:
• Move the slide control to the 'OFF/Phone' position. (B)
• Connect the 3.5-mm jack plug to the socket on your terminal device. (B)
• No additional power supply is required in order to use the microphone with the
terminal device (smartphone etc.).
Connection to a DSLR, camcorder, audio devices or a PC:
• Switch on the microphone by moving the slide control to the 'Camera' position. (C)
• Connect the 3.5-mm jack plug to the socket on your terminal device. (C)
• After use, set the device to the 'OFF/Phone' position to switch off the microphone.
• No additional power supply is required in order to use the microphone with the
terminal device (DSLR, etc.).
5. Warranty Disclaimer
Hama GmbH & Co. KG assumes no liability and provides no warranty for damage
resulting from improper installation/mounting, improper use of the product or from
failure to observe the operating instructions and/or safety notes.

6. Recycling Information

Note - Disposal
Before disposal, cover the contacts of rechargeable batteries/batteries with
insulating or adhesive tape to prevent a risk of short circuits.
4