Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
52
ANGULAR CUTTING
The jigsaw can be used to cut at different angles by adjusting the base plate.
Before adjusting the base plate, make sure that the jigsaw is disconnected from the battery.
1.
To adjust the base plate, loosen the hexagonal screw on the bottom of the jigsaw with the hexagonal spanner.
2.
Slide the base plate forward, tilt it to the desired angle (range: 15°, 30°, 45°) Tighten the hexagonal screw with
the hexagonal key.
3.
Proceed in the same way as for straight cutting, ensuring that the base plate remains flat against the workpiece.
4.
After adjustment, reconnect the battery. Position the guide holder as required, then turn the rotation lever (K) to
the fully rotated position (X).
5.
When releasing, hold the workpiece against the guide bracket so that the cut is straight and tight.
Werbung
Inhaltsverzeichnis
