Remote Control - EUROM Safe-t-Convect Bedienungsanleitung

LED display
The LED display will go dark if no adjustments are
made for 3 minutes. The LED display will light up
again when you press a button.
Status indication (Figure 6, pos. 1):
•
The 3 sun symbols indicate whether the
heater is set to low, medium or high capacity.
•
The ventilator symbol indicates if the turbo
ventilator is enabled.
•
The "P" indicates that the program function is
active.
•
The "M" indicates that the manual function is
active.
Temperature indication (Figure 6, pos. 2):
•
SET indicates that the required temperature is shown on the display.
•
ON indicates that the heater is switched on.
•
OFF indicates that the heater has been switched off by the ON/OFF button.
•
Temperature shown in degree Celsius.
Time indication (Figure 6, pos. 3):
•
Time shown in 24-hours format.
•
The timer symbol indicates when a timer is set.

Remote control*

1. ON/OFF button
2. Max button
3. ECO button
4. Frost button
5. Minus button
6. Timer button
7. Plus button
8. Graph button
9. Ventilator button
10. Mode button
*Batteries not included
Figure 6
Figure 7
19