H-Speed HERAKLES NEO Bedienungsanleitung Seite 22

TASK SETTINGS
Power on the charger and connect a battery, the charger will enter into the standby
page, then short press the roller wheel to activate the program setting menu. The
items in the menu are as follows:
Battery Select battery chemistry
Cells Select number of battery pack cells
Mode Work mode: Charge / Discharge / Storage / Ext.DISC
Select desired charge current (0.1-16.0A),
Current
discharge current (0.1-3.0A)/Ext.discharge(0.1-15.0A)
TVC Terminal voltage control
Start Begin process
Back Return to previous screen or function
The default mode of the HERAKLES NEO is series charging, therefore you must
connect the output wires to the battery pack that you wish to charge.
For lithium packs, it is highly recommended to ALWAYS connect the balance leads
and utilize balance charging. Although the HERAKLES NEO will charge without the
balance function, a warning tone will sound to alert you that the balance connector
is not in use.
• Storage
When selecting the storage function, the HERAKLES NEO will automatically begin
charging if the battery pack voltage is below the ideal storage voltage. Likewise, the
HERAKLES NEO will automatically enter the discharge mode if the battery pack
voltage is higher than the ideal storage voltage.
• Restoring an excessively discharged lithium battery pack
If the HERAKLES NEO detects internal cell voltages that are too low to safely
begin the charging process, it will automatically default to a 0.1A charge rate until
the voltage has risen to a level that allows it to safely accept a fast charge rate.
23 EN