Troubleshooting - VDL Innergize Bedienungsanleitung

ENGLISH
8
Resetting the operating hours counter
Follow these steps to clear the (symbol) symbol from the display:
1 Have the tanning lamps replaced by a VDL Hapro-authorised service centre.
2 Make sure the display is set to 00.
3 Press the buttons in the following sequence:
Start/stop button (
button ( )
The symbol disappears from the display.
Other parts
Have the infrared lamps (1100W) and the UV filters replaced by a service centre authorised
by VDL Hapro. Only they have the knowledge and skills required for this job and the
original spare parts for the appliance.
- Have the infrared lamps replaced when they stop functioning.
- The UV filters protect against exposure to undesired UV light. It is therefore important to
have a damaged or broken filter replaced right away.
- If the mains cord is damaged, you must have it replaced by Philips, a service centre
authorised by VDL Hapro or similarly qualified persons in order to avoid a hazard.

Troubleshooting

If problems should arise with this appliance and you are unable to solve them by means of the
information below, please contact the nearest VDL Hapro dealer.
Problem
The appliance does not
work.
The top of the control
panel becomes hot during
use.
The fuse of the circuit to
which the appliance is
connected cuts off the
power when I switch on or
use the appliance.
), pause button ( ), pause button ( ), repeat button (
Solution
The plug may not be inserted properly in the wall socket. Put the plug
properly in the wall socket.
There may be a power failure. Test if the power supply works by connecting
another appliance.
The tanning lamps may still be too hot to go on. Let them cool down for 3
minutes first.
The overheat protection may have switched off the appliance
automatically because it overheated. Remove the cause of overheating
(e.g. a towel that blocks one or more vents). Let the appliance cool down
for a while and then switch the appliance back on.
Make sure the lamp unit is in the right position. See chapter 'Preparing for
use' .
The lamps heat up the top of the control panel. This is normal.
The fuse of the circuit to which the tanning appliance is connected must
be a 16A standard fuse or a slow-blow automatic fuse. You may also have
connected too many appliances to the same circuit.
), pause