BEARWARE 304751 Bedienungsanleitung Seite 19

Note: The solar light does not require a power source. However, since the light
depends on sunlight, please note the following:
• Make sure that the solar cells get sufficient light during the day. Place the so-
lar panel in a sunny spot. Choose a spot where the panel is exposed to direct
sunlight during the day for as long as possible.
• Avoid an installation site that is entirely or predominantly in the shade.
• In the dark, the light should not be constantly exposed to other light sources.
• The solar module should always be kept free of snow during winter. Remem-
ber that reduced sunlight results in shorter lighting duration.
4. Initial use and installation
1. Take the device out of the package and remove all the packaging material. Please
remove the protective film from the solar panel before using it.
2. Lay the LED string light out. Find a suitable spot with adequate sunlight for the
solar panel. You can also mount the solar panel on the supplied rod and insert it
into the ground. Be careful not to injure yourself!
3. Now lay the string lights, for example, around a bush or shrub. Make sure that
the lights are not immersed in water (e.g., garden pond).
4. Press the switch at the back of the solar panel. The string light is switched on in
the "ON" mode (continuous light). If you press the switch again, you can change
between the 8 different modes.
5. Replacing the rechargeable battery (maintenance)
The capacity of the rechargeable battery decreases after a long period of use of
about one to two years. It then has to be properly replaced. Only a replaceable
battery of the same type may be used.
Remove the four screws at the bottom of the light and separate the bottom part
from the top part.
Unlock the battery compartment carefully and open it. Remove the rechargeable
battery from its bracket.
Insert the new rechargeable battery with the correct polarity. Replace the housing
in the reverse order.
English
19