Control Panel - Pur Line PANEL S Serie Betriebsanleitung

OPERATION

CONTROL PANEL

1. Display (shows the desired room temperature by default).
2. Night mode indicator
3. Day mode indicator
4. Power indicator
5. Increase button
6. Decrease button
7. Night Mode button
8. Day mode button
9. Settings button / Open window function
USE
Warning: Before the heater is turned on, it must be attached to a wall or stand. If the heater
is not installed correctly or is installed askew, this may cause the heater to malfunction or
in the worst case, be damaged.
TEMPERATURE
Press the buttons
TERMOSTAT DAY/NIGHT
Tip! The thermostat can be used as a regular electronic thermostat (i.e. the heater will maintain a constant
temperature 24 hours a day). Please see the section on the electronic thermostat for further information
When programming the heater for either daytime or nighttime setback, the setback period will be active from
the time you register the program. Which means: if you want to start your daytime setback at 7.30am, you need
to register the program at 7.30am.
1 2
3 4
to set the desired temperature.
EN
5 7
6 8
16
9