Werbung
Verfügbare Sprachen
Verfügbare Sprachen
12295 Music stand light
1. Equipment & Dimensions
Light
head
Goose-
neck
rotary
switch
-On/Off
-dimmer
Base
Clamp
0-25 mm
3. Placement of the lamp
3.a to the PLATES
3.a.1
3.a.2
Press the clamp and slide the
...until the plate reaches
music desk or other plate
the inside of the lower end
(max. 25 mm)...
of the clamp
4. Light: Switching and control
The rotary switch on the base serves as:
-ON/OFF switch and -light controller (dimmer)
4.a
LIGHT OFF
- rotary switch on the stop
-
(counterclockwise)
4.b
LIGHT ON
- rotary switch overcomes
-
a resistor (~40º)
4.c
ADJUST THE BRIGHTNESS
- turn the rotary switch as
-
far as desired (stepless)
4.d
MAX. BRIGHTNESS
- Turn the rotary switch
-
clockwise to the end position
12 (2 x 6)
Light diodes
Battery
case
(3 x AA)
3.b.1
Press the clamp and slide
the Lyra placed in the middle
of the note head...
5. Adjust the Light Head
2. Batteries/rechargeable batteries insert or change
2.a
Battery case lid:
Slide the lid with your thumb
(approx. 6 mm) in the direction
of the arrow.
2.d
Place the lid on the compartment
3.b to K&M-NOTE HEADS
3.b.2
...until the plate rea-
ches the inside of the
upper end of the clamp
2.c
Insert three batteries (AA-1.5V) i.e.
2.b
rechargeable batteries (AA-1.2V);
Unlock the lid and lift
(please pay attention to the polls +/-)
2.e
Slide the lid with your thumb
2.f
over the opening until both
After the "click" ensure
hooks click into place
that the lid is securely in place
3.c on TABLES
3.c
and TRAYS
3.c.1
Place the lamp foot
3.c.2
/base on a level
surface. Four
To attain optimal balance
adjust the gooseneck and the
points of support
ensure stability
light head a bit
The highly flexible gooseneck can be used to quickly place
the light in the desired position - and it will stay there until it
is adjusted again.
KÖNIG & MEYER GmbH & Co. KG
Kiesweg 2, 97877 Wertheim, www.k-m.de
12295-000-55 3/18
Werbung
