Cleaning The Device; Changing The Cleaning Barrels - Audiodesksysteme Gläss VINYL CLEANER PRO Bedienungsanleitung

Cleaning the device

8
CAUT ION !
• Pull out the mains plug from the power socket before cleaning the device.
• Do not place the device in water.
• Do not use corrosive or acidic cleaning liquids.
Cleaning the outside surfaces
Outside surfaces can be cleaned with a damp cloth. Use a mild household
detergent to remove excessive dirt.
Cleaning the water tank
Make sure the water tank is fully drained when device is not in use or when you
intend to change the cleaning liquid. Slightly tilt the device before draining, to catch
all possible dirt particles. Then drain some of the liquid. Repeat this process several
times until the water tank is completely empty.
Before storing VINYL CLEANERS PRO rinse out the device with clear water and
let it dry completely.

Changing the cleaning barrels

9
While the four microfiber cleaning barrels last a long time, they should be
replaced after approx. 500 cleaning cycles. This reduces the risk of the records
being scratched by residue on the barrels.
Fixture for the cleaning barrels
b a
1. Pull the cleaning barrels off
in an upward motion.
2. Put new barrels on the shaft
(a) and push down carefully.
3. Rotate the barrels and press
them down slightly until the
drive pins (b) slide into the
corresponding holes in the
barrels.
4. Press the barrels down all
the way to the end stop.
33