INKBIRD IHT-1S Bedienungsanleitung Seite 3

Instruction
● Button Instruction
Short press button can hold the measured
HOLD
° °
F/ C
temperature or cancel the hold temperature when
unit runs. Press and hold the button for 2
HOLD
° °
F/ C
seconds and then release it to switch the
temperature unit between ℉ and ℃.
● How to Calibrate
Press and hold the button for about 8 seconds
HOLD
° °
F/ C
to enter into the calibration mode. LCD screen
shows CA letter. Short press once, it will show the
calibration value and blink, then you can short
press the button to adjust the desired calibration
temperature or hold the button to set fast. The
calibration temperature will be automatically
saved after 10 second if there is no operation.
Notes: The calibration will be reset to 0.0℉/℃ if
you change the temperature unit between ℉ and
℃, the calibration need to be reset.
● LCD Screen (Liquid Crystal Display)
Display the measured temperature, HOLD letter,
charging mark and battery capacity levels.
● Backlight Display
Convenient for check. The backlight will turn off
automatically if there is no operation for 10
seconds or 30 seconds in the HOLD state.
● Rechargeable Lithium Battery