BASETech 84 13 79 Bedienungsanleitung Seite 2

OPERATING INSTRUCTIONS
Key Finder
Item no. 84 13 79
Intended use
The product is used, for example, to find keys. When you whistle briefly, the key finder will emit a sound for a
few seconds and an integrated LED will flash as well.
Always observe the safety instructions and all other information included in these operating instructions.
This product complies with the applicable National and European requirements. All names of companies and
products are the trademarks of the respective owner. All rights reserved.
Package Contents
• Key finder
• Operating Instructions
Safety Instructions
The warranty will be void in the event of damage caused by failure to observe these safety
instructions! We do not assume any liability for any consequential damage!
Nor do we assume any liability for material and personal damage caused by improper use
or non-compliance with the safety instructions! In such cases, the warranty will be null and
void.
• The unauthorised conversion and/or modification of the product is not permitted for safety and
approval reasons (CE).
• The product must not get damp or wet.
• The product is not a toy and must be kept out of the reach of children. It contains small items
and batteries that could be swallowed.
• Attention, LED light! Do not look directly into the LED light! Do not look into the beam directly or
with optical instruments!
• Do not leave packaging material carelessly lying around since it could become a dangerous
plaything for children.
• Handle the product with care, it can be damaged by impacts, blows, or accidental drops, even
from a low height.
Battery Instructions
• Batteries should be kept out of the reach of children.
• Do not leave batteries lying around in the open; there is a risk of them being swallowed by children or
domestic animals. If swallowed, consult a doctor immediately.
• Leaking or damaged batteries can lead to caustic burning of the skin. Therefore, use suitable protective
gloves.
• Batteries/rechargeable batteries must not be short-circuited, opened or thrown into a fire. There is a risk of
explosion!
• Do not recharge normal, non-rechargeable batteries; there is a risk of explosion!
• Do not mix batteries with different charges (e.g. flat and half-discharged batteries).
Getting Started, Use
Before using for the first time, a plastic protective strip must be removed from the key finder. This prevents
the batteries from discharging too early.
After removing the protective strip, the key finder is ready for use.
Fastening the Key Finder (e.g. on a key ring)
Use the metal ring on the key finder for attachment. With this, the key finder, for example can be attached
to a key ring.
Searching for Keys
If you have misplaced the keys, whistle briefly. If the key finder is within range, it responds to the whistle and
emits a beep for a few seconds and an integrated LED flashes as well.
Depending on the location and the volume of the whistle, the key finder reacts to the whistle within a distance
of up to 5 m.
This distance is decreased considerably, if the key finder is inside your pockets, in a drawer or a closet.
Flashlight Function
Press the button on the top of the key finder. As long as you keep this button pressed, the LED at the front
of the key finder is lit. Bear in mind that the battery life is shortened considerably when the flashlight is used
frequently.
Replacing the Battery
The battery needs replacing when the LED only shines weakly or not at all when the button is pressed.
• First, unscrew the two small cross-head screws at the bottom of the key finder.
• Carefully remove the bottom cover. The board with the two batteries is then
visible, see picture on the right.
Version 03/12
• Carefully lift the board a little and push the batteries out to the side.
• Insert two new batteries (button cell type AG3) into the battery holder, paying
attention to the correct polarity.
The positive pole (marked with "+" on the button cell) points outwards, towards you.
• Replace the bottom cover; secure it in place with the screws removed earlier.
Maintenance and Care
Apart from the the occasional battery change the product is maintenance-free.
Please use a soft, dry, clean cloth for cleaning. Do not use aggressive cleaning agents since these might
cause discolouration of the casing.
Disposal
a) Product
Dispose of an unserviceable product in accordance with the relevant statutory regulations.
Remove the inserted batteries and dispose of them separately from the product.
b) Batteries and Rechargeable Batteries
The end user is legally obliged (Battery Regulation) to return used batteries and rechargeable batteries. Do
not dispose of used batteries in the household waste!
Contaminated batteries/rechargeable batteries are labelled with these symbols to indicate that
disposal in the domestic waste is forbidden. The symbols for the relevant heavy metals are:
Cd=Cadmium, Hg=Mercury, Pb=Lead (marked on batteries/rechargeable batteries, e.g. under
the rubbish bin symbol shown to the left).
You can dispose of your used batteries/rechargeable batteries free of charge at your community's collection
point or any place where batteries/rechargeable batteries are sold!
You thereby fulfil your statutory obligations and contribute to the protection of the environment.
Technical Data
Operating voltage ...............3 V/DC
Batteries required ...............2x button cell type AG3 (1.5 V)
Dimensions ........................58.5 x 29 x 15.5 mm (L x W x H)
Weight ................................10 g (incl. batteries)
These operating instructions are a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.
These operating instructions represent the technical status at the time of printing. Changes in technology and equipment reserved.
© Copyright 2012 by Conrad Electronic SE.