Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ATTACHING AND CONNECTING THE ELEMENTS
Attaching the panel
. Remove the front of the street panel by inserting
the spanner supplied in the holes located on the
sides of the panel.
. Connect your wires to the monitor and the lock
as indicated in the diagram below.
. Test your appliance.
. After testing & installing the appliance, place
a clear silicon seal on the top and sides of the
protective rain hood (not on the bottom) to avoid
any risk of infiltration.
Attaching the monitor
Attach the interior monitor at a height of 1.5
metres on a flat wall. First attach the rear plastic
support, connect your wires as indicated in the
diagram below and then push the monitor onto
its support.
WIRE SECTION :
Monitor-camera link
From 0 to 15 metres: use the cable provided.
Extend it if necessary by a maximum of 50
metres with 0.75mm² cable.
CABLING DIAGRAM :
Lock or
SERRURE
opener as
OU GÂCHE
EN OPTION
an option
Camera
CAMERA
ENGLISH
Monitor - automatic opener or lock link
From 0 to 10 metres: use RVV2 *1mm²
cable.
Monitor
MONITEUR
3
AUTOMATED
CONTACT SEC
GATE
SYSTEM
Werbung
Inhaltsverzeichnis
