Operation; Troubleshooting; Maintenance - FF Europe DSTL01 Original Aufbauanleitung

1. Connect the inlet hose to the air source and outlet hose to the air gun.
2. Grip the ball stopper and pull the hose out.
3. To lock the hose, pull the hose and stop at your desired locking position. There are 2-3
locking positions per meter of the hose.
4. To unlock the hose, pull the hose again and retract a little. Then the hose will retract
automatically until the ball stopper hits the housing.
Note:
Always turn off and disconnect the air source and depressurize the hose before retracting.
To better retract the hose, allow it to retract by itself.
The hose may fail to retract automatically after being fully extended. In this case, hold and pull
the hose at the yellow warning mark which can be seen when the hose is fully extended until the
hose retracts.
• Make sure that pressure is released from the hose before maintenance or inspection.
• Clean the hose and main housing with a damp cloth.
• Do not spray water or any other liquid into the reel.
• Only have the reel repaired by the manufacturer or a specialist.
• Store the reel in a clean and dry place, out of reach of children.
DE FR EN ES EN

OPERATION

TROUBLESHOOTING

MAINTENANCE

13