Assembly & Commissioning - Fuxtec FX-DH116 Original Bedienungsanleitung

Original User Manual FUXTEC FX-DH116_rev03
14. Assembly & Commissioning
Mount the device, as shown in the picture.
Start it:
Fill the tank with clean fuel. Use only diesel fuel. You can read the level in the fuel gauge
above the tank. Connect the power cord. Grounding is mandatory. Now the ambient
temperature is displayed. Slide the power switch to "ON." If the temperature control is set
so that the temperature is higher than the ambient temperature, the heater will start after
7 seconds.
If the temperature controller is set lower, the device will not start.
Cold start:
At low temperatures, keep the air vent closed with one finger to start.
If the heater locks up, you will have to do a manual restart:
Check and remove the cause of the lockout before restarting the heater. To reset, set the
On/OFF switch to 0 and then back to I. If the lockout is repeated, contact customer service.
Switch off:
Slide the switch to OFF and disconnect the device from the power supply.
Do not disconnect from the power supply during operation. Keep the device connected
during the cooling sequence. Do not cover the heater. Do not block the air inlet and outlet.
The heater cover is very hot after operation. Do not touch it! Wear protective clothing. Do
not touch the device with wet hands.
26