How To Use - DIAGNOSIS WhiteWay WW-Jet 3000 Bedienungsanleitung

CONFIGURATION
a Nozzle release button
b ON/OFF button
c Mode button
d Mode indicator
e Charging base
f Charging base cover
g Nozzle
h Identification ring
i Nozzle suction tube
j Filter
k Water tank
l Water tank cap
NOTE! There may be some liquid remaining inside the main appliance, this is the
remaining distilled water that was used for the performance test.

HOW TO USE

Charging the device (Fig. 1)
1. Take the charger base cover down and insert the appliance plug
securely into the appliance socket (make sure no liquid
remaining inside the socket before insert the appliance plug).
2. Insert the charging adaptor securely into power outlet.
3. The "CH" indicator blinks when the device is charging and it will
turn off after it's fully charged.
4. Recover the cover onto charger base again after charging
finished.
NOTE! If the "CH" indicator is blinking during or after an
irrigating, that means the battery need to be recharged. An full
recharging will take about 8 hours.
USE THE ORAL IRRIGATOR
Use only filtered water. Do not use any mouthwashes or dilute
them with water.
1. Attach nozzle (irrigator tip onto the unit). (Fig. 2)
2. Open the water tank cap to fill the tank with water which
temperature does not exceed 40ºC, then close the cap. (Fig. 3)
3. Or, Slide the water tank down off the unit, fill the tank with water
which temperature does not exceed 40ºC, then attach the tank
onto the unit. (Fig. 4)
4. Press "Mode" button to select the mode you desired. During
irrigating, you can change the working mode. (Fig. 5)
Normal: for normal cleaning.
l
Soft: for gentle cleaning of sensitive gums.
l
Pulse: for cleaning and massaging the gums.
ź
Hold the unit in an upright position with nozzle tip point toward your
teeth.
6. Keep your mouth opened slightly so that the water can flow out.
3 0 0 0
CHARGING
INDICATOR
Fig.1
insert
Fig.2
Fig.3
Fig.4
slide
down
| 2