Transport, Packaging And Storage - WIKA A2G-200 Betriebsanleitung

3. Safety / 4. Transport, packaging and storage
3.6 Labelling, safety marks
Product label (example)
EN
Model

Measuring range

Output signal


4. Transport, packaging and storage

4.1 Transport
Check the control panel for any damage that may have been caused by transport.
Obvious damage must be reported immediately.
If the instrument is transported from a cold into a warm environment, the formation of
condensation may result in instrument malfunction. Before putting it back into operation,
wait for the instrument temperature and the room temperature to equalise.
4.2 Packaging and storage
Do not remove packaging until just before mounting.
Keep the packaging as it will provide optimum protection during transport (e.g. change
in installation site, sending for repair).
Permissible conditions at the place of storage:
Storage temperature: -20 ... +70 °C
■
Humidity: 0 ... 95 % relative humidity (no condensation)
■
10
Type:
A2G-50
Range: -250 ... +250 Pa
Output: 0 ... 10 V / 4 ... 20 mA
Supply: DC 24 V / AC 24 V ±10 % < 1 W
Made in EU
Supply voltage

Serial number

Before mounting and commissioning the instrument, ensure you read the
operating instructions!
CAUTION!
Damage through improper transport
With improper transport, a high level of damage to property can occur.
▶
When unloading packed goods upon delivery as well as during
internal transport, proceed carefully and observe the symbols on the
packaging.
▶
With internal transport, observe the instructions in chapter 4.2
"Packaging and storage".




E-Nr. 66209848

WIKA operating instructions model A2G-200