JVD RB672 Gebrauchsanweisung Seite 12

register RF again.
•
When the registered CH temperature hasn't received effective signal from the same ID code in
60 minutes, it will display "--.-" and start RF receiving for 3 minutes; if it has received signal from
the same ID code in 3 minutes, it will get out of the receiving mode and enter the common mode;
if it still hasn't received signal from the same ID code in 3 minutes, it will get out of receiving
mode and start RF receiving next hour until the signal received.
2.9. Radio wave receiving condition:
•
After power on or reset and after RF receiving, radio wave receiving starts automatically.
•
Press and hold "DOWN" for 2 seconds to start/exit radio wave receiving forcibly.
•
Receive radio wave automatically every day.
•
Daily receiving
Receive time automatically at every 1:00am, 2:00am, 3:00am. It receives the time at
o
1:00am, 2:00am, 3:00am forcibly. The receiving would last 7 minutes. if succeed, then
it won't receive the time again at same day, if fail, then will receive the time again at
4:00am and 5:00am.
•
Wave receiving feature:
When enter the wave receiving mode, symbol
o
If radio wave received, the symbol
o
frequency.
If the wave is weak and cannot be distinguished, the symbol
o
frequency, the symbol
After the radio signal received successfully, the symbol
o
mode quits.
•
During receiving, press "DOWN" for more than 2 seconds to quit from radio wave receiving
mode. Press "SNOOZE/LIGHT" key to turn on backlight. No effective functions if other keys
pressed.
•
Receiving time is 1:00am of the next day in case the receiving failed.
•
During receiving, it will switch to alarm in case of there's any.
•
If DTS wave is received, the DST symbol will be displayed.
•
After radio wave received, the symbol
disappeared.
is still and the symbol
not displayed.
displayed and if the time re-set, the symbol
twinkling at 1HZ.
twinkling at 1HZ
twinkling at 1HZ
displayed fully, the receiving
12