fontastic SHAGI Bedienungsanleitung Seite 2

GB
User manual
Thank you for purchasing this Fontastic
„Shagi" with active noise cancellation. Please read the
user manual carefully and follow the safety instructions.
Package contents
• 2 x Shagi wireless headset
• Storage and charging case
• USB Type-C™ charging cable
• 3 pairs of ear tips
• User manual
Overview:
1. Microphone
2. Multifunction sensor
3. Earpiece
4. Loudspeaker
5. Charging contacts
6. Headset slot
7. Wireless charging area
(on the back)
8. Charging status indicator
9. USB Type-C™ charging port
(on the bottom)
Getting Started
Charging the headsets
Insert the headsets into the charging case slots. Close
the charging case. By closing the charging case, the
headsets get contact and are automatically charged in
the case.
Charging the case
Charge with cable: Connect the charging cable that
came with the case to the Type-C™ charging input of
the case and a travel charger or USB port of a computer
to charge the built-in battery.
The charge status indicator flashes while charging and
lights up solid when fully charged.
Wireless charging: Place the charging case with the
rear side centered on a connected wireless charging
pad. The LED indicates that the case is charging.
1
TWS Headset
®
2
3
1
4
5
6
8
9
Switching On/Off
Automatic:
Take both headset units out of the charging case, they
turn on automatically. Put the headsets into the charging
case and close it, the headsets turn off automatically.
Manual:
Tap and hold the multifunction sensor for 3 seconds, the
headset will turn on.
Tap and hold the multifunction sensor for 5 seconds, the
headset will turn off.
Note: Both headsets turn on and off automatically
when removed from the case or inserted.
Pairing
The Shagi headset must be paired with a Bluetooth
enabled device to be used.
1. By removing both headset units from the charging
case, they will automatically turn on, sync with each
other, and enter pairing mode to connect to a
Bluetooth
®
7
2. Search for „Shagi" on your Bluetooth
device and select it from the list of found devices to
pair the headset with the Bluetooth device.
Note: When the headset is placed in the charging
case, the connection is interrupted. As soon as
both headsets are removed, they will automatically
reconnect. If the headset units do not connect auto-
matically or an existing connection is disconnected,
switch both headsets off and on again either by
inserting and removing them from the charging
case, or manually.
Note: If the headset does not find a Bluetooth
bled device, it switches off after approx. 3 minutes.
Music Control
All control commands are executed with the
multifunction sensor.
Play/Pause: Tap the multifunction sensor on one of the
two heasdsets once.
Skip Backwards: Tap the multifunction sensor of the
left head 2 times.
Skip Forwards: Tap the multifunction sensor of the right
headset 2 times.
source.
GB
®
enabled
®
-ena-
®
2