Installation; Operation - Titanium 050X Bedienungsanleitung

4. Installation

1. Put the machine on flat table.
2. Insert power plug into the corresponding electric socket and make
sure that working voltage complies with supplying voltage.

5. Operation

1. Set the slide switch to 'AUTO' , at the time, the machine is on
standby; put the shredding paper, vertically into the entry,
thereafter, it starts up automatically and does shredding; it
returns to standby automatically after finishing.
2. When jamming caused by inserting too much paper, or want
to withdraw the paper immediately at the normal shredding,
please set the slide switch to "REV", at the same time, the
machine does the reverse rotation for about 1 second and
returns the paper that has not been shredded; then put the
switch to "OFF".
3. To ensure your machine has a long use life and exerts good
shredding function, please refer notice the maximum number
of shred paper.
4. If the machine works continuously or spasmodically for a long
time, it may pause because the inside temperature increases
continuously. After resting for a period of time, it can work
again.
5. Please do not put clips, adhesive paper, adhesive tapes, or
clothes into the paper entry in order to avoid damaging the
blades or lowering the shredding performance.
6. If you want to clean the wastebasket or the machine, or the
machine is not to use for a long time, please cut off the electric
power and unplug the machi-ne.
6. Nel caso desideriate pulire il cestino di raccolta della carta o
l'intero di- struggidocumenti, scollegate il distruggidocumenti
dall'alimentazione elettrica.
18
050X