Package Contents; Specifications - Anjou AJ-AD012 Bedienungsanleitung

EN

Package Contents

· 1 x Aroma Diffuser
· 1 x Power Adapter
· 1 x Measuring Cup
· 1 x Cleaning Brush
· 1 x User Guide
· 1 x Thank You Card
· 1 x Essential Oil Tube
Specifications
Model
Power Source
Power
Working Time
Mist Output
Water Tank Volume
Ultrasonic Frequency
How to Use
Caution
1) Please add water to the tank first, then pour essential oils up to the
marking on the tube or until dispensing starts. If there's no
fragrance, the water-oil balance may be off. Please add enough
essential oil as instructed then.
2) If you are using a glass essential oil tube, please handle with care
to avoid breakage.
AJ-AD012
24V / 500mA
12W
6-10h (High Mist)
10-15h (Low Mist)
60 ml / 2.0 fl. oz (High Mist)
30 ml / 1.0 fl. oz (Low Mist)
500 mL / 17.0 fl. oz
2.4MHz
3) It is recommended to use purified or distilled water.
Add and Drain Water
1. Remove the tank cover, add water into the tank no higher than the
max water level line. Drizzle a few drops of essential oil into the
tube until dispensing starts. Put the tank cover back on.
2. Drain excess water via the drain side if necessary.
3. Clean the water tank with the included brush when grime builds up.
Note:
Never pour essential oils into the tube when there is no water inside
the tank.
Operations and Functions
Connect to a power source. Once connected the diffuser will enter
standby mode. Please make sure there is enough water inside the
tank.
Power On / Off the Mist
1. Press the Power / Mist Button once to enter the default high mist
mode. Two beeps will sound and the ON indicator will light up.
2. Press it again to enter low mist mode with one beep sound.
3. Press a third time to resume high misting. Press one more time to
switch back to low misting. Shift between the two modes with each
press.
4. Press and hold the Power / Mist Button for 2 seconds to turn off
the misting.
Timer Setting
1. When the unit is on, press the Timer Button to set 1 / 4 / 8 hours
timer or turn off the timer. The corresponding indicator will light up.
2. When the timer is on, press and hold the Timer Button for 2 seconds
to turn off the timer at any time.
01/02