Safety Instructions - nedis WIFILOFC20FBK Kurzanleitung

Junction box cover
6
Mounting bracket
7
* WIFILOFS20FBK only.

Safety instructions

-
WARNING
• Ensure you have fully read and understood the instructions in
this document before you install or use the product. Keep the
packaging and this document for future reference.
• Only use the product as described in this document.
• Do not use the product if a part is damaged or defective.
Replace a damaged or defective product immediately.
• Do not drop the product and avoid bumping.
• This product may only be serviced by a qualified technician
for maintenance to reduce the risk of electric shock.
• Disconnect the product from the power source and other
equipment if problems occur.
• Disconnect the product from the power source before service
and when replacing parts.
• Only use the provided power cable.
• Do not unplug the product by pulling on the cable. Always
grasp the plug and pull.
• Children should be supervised to ensure that they do not
play with the product.
• Only power the product with the voltage corresponding to
the markings on the product.
• Do not look directly into the light, this may cause eye
damage.
• Some wireless products may interfere with implantable
medical devices and other medical equipment, such as
pacemakers, cochlear implants and hearing aids. Consult the
manufacturer of your medical equipment for more
information.
• Do not use the product at locations where the use of wireless
devices is prohibited due to potential interference with other
electronic devices, which may cause safety hazards.
Install the mounting bracket
Make sure the power cable is disconnected from the power
4
outlet.
1. Check what plugs and screws are best suited for the
intended surface.
The maximum diameter of A
4
2. Remove the mounting bracket bolts A
3. Remove the mounting bracket A
4. Use A
7 to mark the drill locations with a pencil.
7 is 4.5 mm.
from the product.
5
from the product.
7
5