Manhattan 207683 Anleitung Seite 3

Instructions
11
1
1 HDMI IN: Connect input source.
2 HDMI OUT (both units): Connect
output display/projector at
sender side for loop out and at
receiver side for remote out.
3 USB/PC: Connect to computer
source to control it through
Receiver's USB ports.
4 Power LED: lights when power is
connected;
USB: lights when connected
11
2
7 USB: In Allocation Mode, press to
control source at selected receiver.
8 Connect USB keyboard and mouse.
9 POWER LED: lights when power is
connected;
Keyboard LED: lights when
connected to keyboard;
Mouse LED: lights when
connected to mouse.
TRANSMITTER
2 3
RECEIVER
7 8
4
to a computer.
5 IR TX: Connect IR Transmitter (TX) to
send IR remote signal to source; place
it in line of sight to source sensor.
6 LAN TX / LAN RX: Use Cat6 cable to
connect to units to each other or to a
switch, depending on desired setup
(green LED: lit = power, off =
no power; yellow LED: slow
flashing = no video signal; fast
flashing = video signal).
9
10 IR RX: Connect IR Receiver
(RX) to receive IR remote signal
at display location; place it in
line of sight to remote.
11 DC 5V (both units): Connect
included power adapters.
12 RESET (both units): Press
to perform a restart.
12
5 6
10 6 12
English
3