ATOMSTACK M50 Installationsanleitung Seite 3

Part 1： Security Statment and warning
Before Using the laser engraving, please read this safety guide carefully, it mentions situations that require special
attention and includes warnings of unsafe practices that can cause damage to your property or even endanger your
personal safety.
1. This product is a laser engraver system components, must be installed in other manufacturers of laser engraver for
use.And the product belongs to Class 4 laser products, the laser system itself must meet the requirements of IEC 60825-1
latest version, otherwise the product is prohibited to be used.
2. Your laser engraver shall have a protective housing which, when in place, prevents human access to laser radiation.
3. If a protective housing is equipped with an access panel which provides "walk-in" access then:
a)means shall be provided so that any person inside the protective housing can prevent activation of a laser hazard that is
equivalent to Class 3B or Class 4.
b）a warning device shall be situated so as to provide adequate warning of emission of laser radiation equivalent to Class
3R in the wavelength range below 400 nm and above 700 nm, or of laser radiation equivalent to Class 3B or Class 4 to any
person who might be within the protective housing.
c) where "walk-in" access during operation is intended or reasonably foreseeable, emission of laser radiation that is
equivalent to Class 3B or Class 4 while someone is present inside the protective housing of a Class 1, Class 2, or Class 3R
product shall be prevented by engineering means.
NOTE Methods to prevent human access to radiation when persons are inside the protective housing can include
pressure sensitive floor mats, infrared detectors, etc.