SCALESON S120 Gebrauchsanweisung Seite 20

7. Display and fault messages
Display
dc x.xx
------
P-OFF
bATLo
c _End
Err-0
Err01
Err02
Err03
Err08
C_End
20
The battery voltage is x.xx Volt
The scale capacity has been exceeded. Reduce the weight on the
platform
Automatic switch-off at low battery voltage
The battery is low and should be charged soon
Charging of the battery is complete
The scale was overloaded. Remove the weight, zero the scale and
try again. If the error code persists, the load cell has been
damaged. The load cells are not user-replaceable. Contact the
manufacturer
CAL switch is OFF
The sample weight is too small in count mode
The weight used for calibration is too small
Chip error
Battery charging completed
Message