Packwise Smart Cap Montageanleitung Seite 14

Step 2: Activate sensor
1) Remove the rubber stopper from the bottom side
of the device and take out the magnet inside to
activate the sensor.
2) Place back the rubber stopper. Put the magnet
aside. Please keep the magnet for later
deactivation.
IMPORTANT: The magnet must remain permanently
removed, otherwise the device will be deactivated again.
NOTE: The Packwise Smart Cap should be attached to
the container (Step 3) within 2 minutes of its activation
(Step 2).
14 MA_SC1_8_21_V02