Need4Stream N4S300 Gebrauchsanleitung Seite 27

The Bluetooth connection got established but the vehicle still
shows "no device connected".
Solution 1: Check if the device is really correct

connected.
Solution 2: Unplug the adapter and connect it again.

Solution 3: Reboot the phone and turn off ignition of the

car to initialize both.
Ignition of the vehicle is off. However, the blue LED of the
adapter is still on and Bluetooth is connected.
It can take a few minutes until the car gets into sleep mode.
Until that, the blue LED is still on as the device gets power
from the car. Once the blue LED goes off, the car is in sleep
mode and the device does not consume power.
Can I connect my phone with the existing handsfree and
Need4Stream at the same time?
Yes, this is possible. Connect the handsfree with the HFP
protocol (Phone) and Need4Stream with the A2DP protocol
(Music). Once a call comes in, the radio will mute the stream
and continue later.
The music sometimes interrupts. What can I do?
When the phone is connected to handsfree and Need4Stream
at the same time, it can happen that the bandwidth for data
transfer is insufficient. Disconnect the handsfree to figure out
if this is the reason.
www.need4stream.de
EN
27