INTERTECHNO PIR-6000 Bedienungsanleitung Seite 19

GB
The wireless motion detector has a fixed code and can therefore
only be used by intertechno self-learning wireless receivers to
switch devices ON/OFF.
Inserting the batteries
Remove the motion detector from the housing (Fig.1)
Unscrew the two crosshead screws.
Lift off the case using a screwdriver.
Insert two AAA 1.5 V alkaline batteries (Fig.2)
An LED in the sensor will flash when the batteries need to be
replaced.
The following settings and coding can be set once you have opened
the case.
Settings (Fig. 2)
A Switch-off time (5 sec./1 min./5 min./10 min.)
The time it takes for the device to switch off after the detection
area has been triggered.
)
B Light sensitivity H/M/L(Day/Evening/Night).
H: 24-hour operation.
The device can detect motion at any time in this mode.
e.g: to operate a wireless bell (e.g. IT-7000, IT-9000)
M: Triggers at twilight below 20 +/- 5 lux.
L: Triggers at a brightness level below 10 +/- 5 lux.
C Set the slider to DEL.
Coding: Teaching-in a wireless receiver (Fig.3)
Please also refer to the wireless receiver's instruction manual when
coding.
1) Place the wireless motion detector near to the wireless receiver.
2.) Switch the wireless receiver to learn mode.
(e.g. by pressing the learn button)
3) Then move the slider (C) from DEL to SET (ON signal).
The coding will be saved.
To delete the coding, do the same as above but move the slider
from SET to DEL (OFF signal).
Operating instructions
PIR-6000
›