Reset Device; E) Low Light Recording; Motion Detection - Sygonix SY-DB-500 Bedienungsanleitung

d) Reset device
• If the product is not working correctly, press and hold the reset
button to perform a reset.
• The device will enter pairing mode after restarting.
• Any previous connections will be lost and the device will be
open for pairing.

e) Low light recording

Do not place the camera behind glass, glare from the
infrared LED light may overexpose the image.
• The device is equipped with a sensor that triggers "night vi-
sion" when the ambient light falls below a certain level.
• The light has a range of approximately 3 m.
• The recorded image will be in black and white.
f) Motion detection
When motion is detected, a push alarm notification will be sent to
your mobile device.
• With microSD inserted: 60 second clips will be saved.
• There are two kinds of recording (event and non-stop). These
settings are accessed through the application. The Default
time for event recording is 60 seconds.
• Cloud storage service: If subscribed to this service through
the application, motion triggered recording will be saved to
your cloud storage account. You do not need an SD card.
44