Operation Of The Unit - Textron Klauke HK60 VPFT Bedienungsanleitung

Instruction Manual HK60 VPFT
_____________________________________________________________________________
5. Remarks in respect of the determined use

5.1. Operation of the unit

In order to start the crimping procedure the turn screw (Pos.-No. 6) must be turned 180°
while the pump lever (Pos.-No. 3) is pushed towards the handle (Pos.-No. 5).
Afterwards the crimping head must be opened by pulling out the locking pin (Pos.-No. 8)
and removing the latch (Pos.-No. 7). The connecting material must be positioned right in the
center of the four indenters.
Attention
If the connector is crimped in an out-of-center position the crimping head can
damaged.
A crimping process is initiated by activating the pump lever (Pos.-No. 3). The three
moveable indenters approach the connecting material simultaneously.
The tool is equipped with a double piston pump which is characterised by a fast approach of
the indenters towards the connecting material and a slow working stroke. In the low pressure
mode the fast approach is realised while opening the pump lever (Pos.-No. 3) and the slow
by closing it. In the high pressure mode the compression is realised by closing the pump
lever only.
Instruction manual HK60 VPFT
___________________________________________________________________________
5. Remarks in respect of the determined use
5.1. Operation of the unit
In order to start the crimping procedure the turn screw (Pos.-No. 6) must be turned 180°
while the pump lever (Pos.-No. 3) is pushed towards the handle (Pos.-No. 5).
Afterwards the crimping head must be opened by pulling out the locking pin (Pos.-No. 8)
and removing the latch (Pos.-No. 7). The connecting material must be positioned right in the
center of the four indenters.
Attention
If the connector is crimped in an out-of-center position the crimping head can
damaged.
A crimping process is initiated by activating the pump lever (Pos.-No. 3). The three
moveable indenters approach the connecting material simultaneously.
The tool is equipped with a double piston pump which is characterised by a fast approach of
the indenters towards the connecting material and a slow working stroke. In the low pressure
mode the fast approach is realised while opening the pump lever (Pos.-No. 3) and the slow
by closing it. In the high pressure mode the compression is realised by closing the pump
lever only.
All manuals and user guides at all-guides.com
page 17
page 17