Symbol LL 500 Kurzübersicht Seite 5

Putting It Together
1. Be sure your host device is powered down.
2. Connect the 40-pin connector on the host cable to the
HOST port on the LL 500. If your cable doesn't have a
40-pin connector, proceed to step 5.
3. The other end of the host cable should match one of the
following:
• The input port on your host. This may be an OCIA,
OCR, IBM 468x/9x, or RS-232C terminal.
• A POS Internal connection. In this case you'll have to
open up your POS terminal and connect the cable
internally. This procedure is described for some of the
most popular terminals in the LL 500 Product
Reference Guide.
• A keyboard wedge. The LL 500 is physically connected
between the terminal and the keyboard. To do this:
Host Cable
3