Blaupunkt HOS-X20 Bedienungsanleitung Seite 10

6. Live View Functionality
Step 1:
Launch the OMGuard HD app.
Step 2:
On the LampCam list menu double tap the desired LampCam to access livestream.
Step 3:
For security reasons the first time you log in to the LampCam the APP will request to
modify the default Security code. (The Security Code is used to establish a communication
between the LampCam and the smartphone. This is not the same as the Admin password).
We recommend to write down this password in a safe place. Otherwise if you forget it you
would need to factory reset the camera.
Step 4:
Refer to the bellow table to learn more about the operations that are available on the Live
Stream menu.
10
Click on the arm / disarm button to arm or disarm the LampCam.
The App will ask for the admin code to perform this action.
If the camera detects movement during arm mode, it will send a push
notification and start a 60s video recording.
Note: Push notifications and PIR motion detection need to remain en-
abled in advanced settings (enabled by default).
Take a snapshot from the current video stream.
The Snapshot will be stored on the smartphone and can be found on
your smartphone photo gallery.
Start a 60 seconds video recording without pause to the LampCam
micro-SD card. SD-Card Is mandatory for this feature.
To find the videos please refer to the "Event playback" menu.
Activates / deactivates the microphone to listen through LampCam.
Push To Talk button: Push this button and keep pressing to talk from your
Mobile Phone through the LampCam. To stop talking release the button.
Tap this button to launch a 60 seconds siren alarm. It's possible to stop
the siren by tapping the icon again.
Return to LampCam list menu
Slide the bar to adjust the brightness of the LampCam from 0 to 800lm.
Tap the bulb icon to turn the light ON / OFF or AUTO.
ON: The light of the LampCam will be turned ON permanently.
OFF: The light of the LampCam will be turned OFF.
AUTO: The light will turn ON automatically according to your lighting
trigger setting. see chapter 5.2.
PIR trigger for movement detection and manual schedule will work only
under AUTO.