AS NOVA P20 Benutzerhandbuch Seite 13

6. After the system recovery is completed, eject the the
Recovery DVD from the optical drive.
Restart the system and press <DEL> on bootup to enter the
7.
BIOS setup. Go to Boot > Boot Device Priority and reset the
hard disk drive (may be labeled as "HDD:XXXX") as the st
Boot Device.
8. Press <F10> to save the configuration and reboot the
system.
9. Insert the Support DVD into the optical drive.
0. Click ASUS InstAll - Drivers Installation Wizard from the
Drivers tab and install all the drivers.
It may take some time to reinstall all the drivers. If the
screensaver starts, press any key to bring back the installation
screen.
Crashfree BIOS
ASUS Crashfree BIOS allows you to restore the original BIOS data
from the support DVD in case when the BIOS update fails or the
BIOS codes and data are corrupted. Change the boot priority and
boot from your support DVD to restore your BIOS.
When you notice the
power LED blinks white
and hear two short
beeps followed by one
continuous beep at the
system startup, your BIOS codes are damaged.
Follow the instructions below to restore your BIOS:
. Insert the Support DVD. The system will give two short beeps
and start restoring the BIOS. (No display on screen)
2. When the power LED stops blinking, the restoration is
completed.
. Press the power switch to start the system. If the system
enters Windows OS, the BIOS has been restored.
power LED
ASUS NOVA P20/P22