HomeMatic IP HmIP-DRSI1 Installations- Und Bedienungsanleitung Seite 41

Hazard information
The actuator is part of the building installation.
The relevant national standards and directives
must be taken into consideration during planning
and set-up. The device has been designed solely
for operation on a 230 V/50 Hz AC supply. Only
qualified electricians (to VDE 0100) are permitted
to carry out work on the 230 V mains. Applicable
accident prevention regulations must be com-
plied with whilst such work is being carried out.
To avoid electric shocks from the device, please
disconnect the mains voltage (trip the miniature
circuit-breaker). Non-compliance with the instal-
lation instructions can cause fire or introduce
other hazards.
When connecting to the device terminals, take
the permissible cables and cable cross sections
into account.
Connected loads require sufficient insulation.
Exceeding this capacity could lead to the de-
struction of the device, fires or electric shocks.
Before installation and connection of the device,
mains voltage must be disconnected and live
parts in the surrounding must be covered.
41