Walter WWS-4TS Bedienungsanleitung Seite 67

Starting the power generator
• Push the overload protection switch
• If necessary, disconnect the mains plugs of any electrical devices that are
connected.
• Check the engine oil level (see chapter "Checking the engine oil level").
• Check the air filters (see chapter "Cleaning the air filter").
• Check the ventilation grills and slits for dirt accumulation (see chapter
"Checking the ventilation grills and slits").
• Carry out a visual inspection and check if all the parts are clean and
undamaged.
• If you start the power generator in a room, connect an exhaust gas hose to
the power generator and switch on the extraction device.
• Open the Petrol cock
turn it clockwise until the side-piece
points vertically downwards.
• Push the On/Off switch of the
15
generator
• Press the choke lever
the left as far as it goes.
• Hold the frame of the power
generator firmly with one hand.
• Grasp the handle
starter and pull it carefully until you
feel some resistance.
• Pull the handle with impetus.
• Repeat the last two steps if the power generator has not started.
• If the power generator has started, slowly push the choke lever to the right as
far as it goes.
• Allow the power generator to run for at least one minute without connecting
any electrical devices.
K640061_Anleitung_DE_EN_FR_CZ_SI.indb 67 K640061_Anleitung_DE_EN_FR_CZ_SI.indb 67
18
. To do so,
to "ON".
16
carefully to
17
of the pull-
Using the power generator
11
down to "OFF" position.
18
16
17
67
08.02.2021 14:53:27 08.02.2021 14:53:27