Herunterladen Diese Seite drucken
ComAp AutoSarSimplex Montage- Und Serviceanleitung
ComAp AutoSarSimplex Montage- Und Serviceanleitung

ComAp AutoSarSimplex Montage- Und Serviceanleitung

Autobalancing thermostatic radiator valve autobalancing thermostatic radiator valve

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

AutoSar
Autobalancing Thermostatic Radiator Valve
Autobalancing Thermostatic Radiator Valve
ENG
Installation and operating instruction
DEU
Montage- und Serviceanleitung
NLD
Installatie- en bedieningshandleiding
FRA
Installation et mode d'emploi
www.flamcogroup.com/manuals
3
4
5
6

Werbung

loading

Inhaltszusammenfassung für ComAp AutoSarSimplex

  • Seite 1 AutoSar Autobalancing Thermostatic Radiator Valve Autobalancing Thermostatic Radiator Valve Installation and operating instruction Montage- und Serviceanleitung Installatie- en bedieningshandleiding Installation et mode d’emploi www.flamcogroup.com/manuals...
  • Seite 2 AutoSar...
  • Seite 3 Setting Flow l/h between 0,1 and 0,6 bar P 2,5 P 3,5 P 4,5 P 5,5 Adjustment principle of Kv The adjustment of the desired flow should be using the embedded tool that displays the 12 adjustment positions. Turn the tool with a screwdriver as shown in the diagram below. Place the number corresponding to the desired flow in front of the indicator located on the hat.
  • Seite 4: Nominale Pegeleinstellung

    Einstellung Durchfluss l/h zwischen 0,1 und 0,6 bar P 2,5 P 3,5 P 4,5 P 5,5 Einstellung Kv Die Einstellung des gewünschten Durchflusses sollte mit der Einstellhilfe erfolgen, welche die 12 Einstellpositionen anzeigt. Drehen Sie die Einstellhilfe mit einem Schraubendreher wie in der Abbildung unten gezeigt.
  • Seite 5 Voorinstelling Debiet l/h tussen 0,1 en 0,6 bar P 2,5 P 3,5 P 4,5 P 5,5 Instellingsprincipe van de Kv Het debiet wordt op de gewenste waarde ingesteld met behulp van de ingebouwde appendage waarop de 12 regelstanden zijn aangeduid. De appendage met een schroevendraaier op de juiste stand zetten, zoals hieronder afgebeeld.
  • Seite 6 Pré-réglage Débit en l/h entre 0,1 et 0,6 P 2,5 P 3,5 P 4,5 P 5,5 Principe de réglage du Kv Le réglage du débit souhaité doit se faire à l’aide de l’outil embarqué sur lequel figure les 12 positions de réglage.
  • Seite 7 +36 23 503 871 info@flamco.de info@flamco.hu comap.hungary@comap.eu Italy Poland Distributore: Commerciale Delta Flamco Meibes Sp. z o.o. Comap Polska Sp. z o.o. +48 22 679 00 25 +39 (0)2 242 8303 +48 65 529 49 89 vendite@commercialedelta.it info@flamco.pl comap@comap.pl Slovakia Russian Federation Flamco SK s.r.o.
  • Seite 8 Copyright Flamco B.V., Almere, the Netherlands. No part of this publication may be reproduced or published in any way without explicit permission and mention of the source. The data listed are solely applicable to Flamco products. Flamco B.V. shall accept no liability whatsoever for incorrect use, application or interpretation of the technical information.