Setup; Installation; Connections - Steinigke Showtechnic OMNITRONIC PM-311P Bedienungsanleitung

5 Setup

5.1 Installation

Set up the mixer on a plane surface. Please make sure that there is enough space around the unit for
ventilation to improve heat dissipation. Steady overheating will damage the unit.

5.2 Connections

Switch off the mixer prior to connecting any units or to changing any existing connections.
1) Connect the stereo audio sources to the corresponding RCA jacks (white jack = left channel; red jack =
right channel):
• You can connect units both with line level output (e.g. CD players) and turntables with magnetic system
to the RCA input jacks CH 1 IN and CH 3 IN. If your turntable is equipped with a separate ground lead,
connect it to the clamping screw.
• Connect units with line level output (e. g. CD players) to the RCA input jacks CH 2 IN only.
2) Connect a dynamic DJ microphone with an unbalanced 6.3 mm plug to the microphone input MIC.
3) Connect the amplifier to the unbalanced RCA master output.
4) For sound recordings, connect the recording unit to the output REC OUT. The recording level is
independent of the position of the master control.
5) For prefader listening to the input channels or for monitoring the current music program ahead of the
master control, it is possible to connect stereo headphones to the 6.3 mm jack HEAPHONES.
6) Connect the cable of the power unit to the power input and the power unit to a power outlet.
• Use the mixer only with the supplied power unit. Always disconnect the mains connector when you wish
to change connections, move the unit to a different place or if it is not used for a longer period.
14 • EN