Sauter FTP-GTS10 Einbauanleitung Seite 3

Installing the FTP-GTS10/HPL-GTS10 in the Bosch Table Saw GTS10XC
1
Loosen all 4 screws at the end of the table
extension.
If necessary, use the shims to compensate for any
height differences (supplied).
2
Take out the end plate
4
replace the end plate and replace the screws from Fig.1
3
Push the router table plate FTP-GTS10 between the
grooves as far as possible.
5
Place and secure your insert plate or router lift with
the mounted router/router motor in the FTP-GTS10.
6