Brake; Seat Height Adjustment; Adjusting The Height Of The Trunk Support; Tilt Function - Vela Meywalk 4 Micro Benutzerhandbuch

E N

2.0.5. BRAKE

The brake rods are located in front of the rear wheels. Move
both brake rods backwards to activate the brake function on
both sides. The brakes are deactivated by moving both brake
rods forward again. Note: The brake must always be locked
when getting in and out of the gait trainer.

2.0.6. SEAT HEIGHT ADJUSTMENT

Loosen the lower hand screw (push-and-turn) on the front of the
gait trainer. The seat can now be adjusted up and down. A hand
under the seat bracket makes the seat slide easy. Adjust the seat
height to the user's stride length and retighten the hand screw so
that the seat bracket locks are in place. Note: Never adjust the
height of the seat while the gait trainer is in use.

2.0.7. ADJUSTING THE HEIGHT OF THE TRUNK SUPPORT

Loosen the upper hand screw (push-and-turn) on the front of
the gait trainer. Adjust the trunk support to the desired height
and retighten the hand screw. Correct height depends on the
user's physique and need for free movement. Loosen the two
Allen screws on the front of the trunk support to replace it. Note:
Never replace the trunk support while the gait trainer is in use.

2.0.8. TILT FUNCTION

Turn the center hand screw on the front of the gait trainer
to tilt. Turning the hand screw modifies the angle of the
trunk support and seat so the user's posture changes. The tilt
function is stepless. Note: Never adjust the tilt while the gait
trainer is in use.
1 3