Blaupunkt GRS501 Bedienungsanleitung Seite 7

GRS501
1. Lid
2. Buckle
3. Power indicator light
4. Thermostat/Ready indicator light
5. Plates
BEFORE FIRST USE
1. Remove all the cardboards, papers, foils which secure the appliance and it's parts.
It is recommended to turn on the device first to „burn it out". Keep the appliance operate for few
minutes to get rid of manufacturing odour. Device could emit some smoke. That's normal.
2. Clean the device with suggestion mentioned in chapter CLEANING AND MAINTENECE.
REMOVABLE PLATES
To remove the plates, release the locked latches blocking heating plates and remove the plates. To
insert plates, embed plate into catches and then press it to snap blocked the plate.
USING THE DEVICE
Prepare all ingredients.
1. Connect the device to the power supply. The power indicator light will turn on. Turn the thermostat
knob clockwise to the MAX position. The thermostat light should be off or unlit. The device will warm
up.
2. When the device warms up and reaches the desired temperature, the thermostat indicator light will
light up. The device is ready for operation.
3. Place the prepared ingredients for grilling on the grilling plates. If necessary, close the lid. Turn the
thermostat knob to the desired temperature.
4. During the operation of the device, the thermostat indicator light will turn off and on, the device will
maintain the optimal temperature.
5. The cooking time is between 10 and 30 minutes, depending on the type of ingredients and taste
preferences.
ATTENTION: During cooking, some steam can go out from under the lid.
6. To take prepared food out open the lid and use plastic or wooden utensils.
7. Before grilling another portion, close the lid and wait for the heating plates to heat up. The
thermostat indicator light will come on when the grill is ready.
8. After use disconnect the plug and let the device cool down.
Grill can work as a open grill when lid opened by 180 degree. Ingredients will be grilled by one side,
and grilling surface will be doubled.
CLEANING AND MAINTENANCE
1. Before cleaning, disconnect the plug from mains and wait until device cool down.
2. Clean with dump cloth, then dry with dry cloth or paper towel.
3. To clean stubborn remains spread a small amount of cooking oil, and after a few minutes, gently
remove it with a wooden spatula.
4. Do not clean the heating plates with sharp, abrasive cloths or sponges, or use scouring powder
because they can damage the smooth non-stick coating of the plates.
5. Do not immerse device in water.
6. Plate's locks
7. Thermostat knob
8. Handle
9. Drip tray
5