Installation Instructions; Step A - Install Water Supply Fittings; Step B - Make Tubing Connections - AEG PREMIUM Installations- Und Bedienungsanleitung

Vorschau ausblenden

Inhaltsverzeichnis

Verfügbare Sprachen

STEP A - INSTALL WATER SUPPLY FITTINGS

Check and comply with local plumbing codes as you plan, then install the fittings to connect the undersink

filter into the sink's cold water supply line. Fittings and 9.5 mm (3/8") O.D. tubing are included to provide

connections to and from the undersink filter's inlet and outlet. A typical connection using the included water

supply fittings is shown in Figure 3.

1. Close the sink's water shut off valve(s), or another shut off valve upstream from where you will install the

filter, and open faucets to relieve pressure from the sink's cold water supply line.

2. Locate the line supplying cold water to the sink faucet. Typically this line will be a flexible hose. Disconnect

the nut that connects this line to the cold water pipe. Use a bucket to catch water that drains from this line.

3. Locate the supplied male threaded adaptor fitting (See Fig. 3) and, using thread sealing tape, install it into

the nut on the faucet supply line which you disconnected in Step 2.

4. Locate the supplied female threaded adaptor fitting (See Fig. 3) and, using thread sealing tape, install it

onto the cold water supply pipe. If the threaded portion of the water supply pipe is too short to insert fully into

the adaptor fitting (about 10.4 mm), place the supplied washer inside, as shown in Figure 3.

9.5 mm (3/8")

tubing to water

filter INLET

female

threaded

adaptor fitting

washer

(if needed)

cold water shutoff

STEP B - MAKE TUBING CONNECTIONS

NOTE: Remove protective foam plugs before connecting tubes (See Fig. 4). Discard foam plugs.

1. Locate one piece of the supplied 9.5 mm tubing. Connect it between the adaptor that you installed on the

sink line and the filter system outlet (See Figures 2 & 3). Allowing some slack, measure and cut to length. Cut

the ends of the tubing square.

2. Insert tubing all the way into the quick connect fittings on the adaptor and filter system outlet. Pull on

the tubing to be sure that it's held firmly in the fittings.

3. Repeat steps 1 and 2 to connect the other piece of 9.5 mm tubing from the adaptor that you installed on

the cold water supply to the filter system inlet (See Figures 2 & 3).

Tubing Connection (all push-in fitting locations):

This system includes push-in fittings for quick tubing connections. When working with the fittings, do the

following.