Beck com.tom INDUSTRY 100 Inbetriebnahmeanleitung

com.tom INDUSTRY 100
Start-up Guide
The CTI 100 devices communicate with the com.tom PORTAL via
Ethernet and the existing network infrastructure. The communica-
tion mechanism has a low data volume and can be integrated easily
in existing network infrastructures.
The device may be put into service and
operated by qualified personnel only.
The device is designed for an installation on a
grounded 35 mm DIN rail in dry rooms.
The power supply of the device must be a
grounded circuit PELV (connection between
functional earth and ground). The power
supply must be a limited power source ac-
cording to the EN60950-1 chap. 2.5 or must
be provided with an anti-surge fuse of 2 A.
Pin Assignment
Power Supply
PIN Description
FE Functional earth
GND Ground
VCC 24 VDC
Serial Interface (COM)
Pin RS232
Pin 1 COM_GND
Pin 2 CTS
Pin 3 -
Pin 4 Tx
Pin 5 -
Pin 6 RTS
Pin 7 -
Pin 8 Rx
CAN Interface
Pin Description
Pin 1 CAN High
Pin 2 TERM
Pin 3 CAN Low
Pin 4 CAN_GND
Ethernet Interface
Yellow LED Link indication
Green LED Activity indication
RS485
COM_GND
-
B (+/Z)
-
A (-/Y)
-
TERM_B
-
Status LEDs
PLC PLC status
Portal Portal status
LED 3 Freely programmable
LED 4 Freely programmable
Power Device is powered
Other Interfaces
SD card interface microSD card
USB interface Micro USB (OTG Host & Slave)
Getting Started
Wire the com.tom device according to the technical data. Get
the appropriate
Getting
http://www.com-tom.de/start and follow the steps described
there to put your device into operation.
Part Numbers
00571144 (WEB-PLC) CTI 100.W
00571237 (CODESYS) CTI 100.C
General Data
Size (W x L x H) 46 x 103 x 63 mm
Operating temperature 0 bis 55 °C
Electrical shock Class III
Protection rating IP20
EMC emission IEC 61000-6-3
EMC immunity IEC 61000-6-2
Compliance CE, RoHS
Electrical Data
Supply voltage
24 VDC (15 %)
Active current < 100 mA
Scope of supply
1 Piece CTI 100
1 Piece microSD card
1 Piece Start-up guide
1 Piece Connector 3-pin
1 Piece Connector 8-pin
1 Piece Connector 4-pin
1 Piece Label MAC-ID
documentation at
Started
Copyright © 2018 Beck IPC GmbH
http://www.com-tom.de