Switching Off; Cleaning And Maintenance - Kinzo 71778 Anweisungen

A
SwiTchinG on
Switch the angle grinder on by depress the rear position of the ON/OFF switch button (3) as the arrows on
the Fig.9 shown and pushing the switch button forward and lock onto the "On" position. (See Fig. 10)

SwiTchinG off

Depress the rear position of the ON/OFF switch button (3), it returns automatically to the "Off" position and
the tool turns off (See Fig. 9 and 10). Do not let go of grinder until it has stopped running.
Warning: The wheel continues to rotate after the tool is switched off.
uSe
GRINDING
Hold the handle and auxiliary handle (4) firmly and switch on. Avoid blocking the ventilation slots with your
hand, as this may cause the grinder to overheat. Let the disc reach full speed.
Apply the grinder to the item. Maximum effect is achieved when the grinder is held at an angle of 15-30°in
relation to the item. Move the grinder gently along the item. Give the grinder time to work. It is rarely neces-
sary to press the disc hard against the surface to be worked.
Sparks can occur in the motor compartment during use. This is normal and does not mean the grinder is
defective.
Switch off the grinder after use.
SPLITTING
Splinters of splitting disc may be ejected at a very high speed.
– Do not apply any side pressure to the wheel, as the cutting wheel can jam and burst.
Fig. 11
1. Fit the splitting disc.
2. Switch the tool on and run it first without load.
3. Hold the motor block at an angle between 30°and 45°to the workpiece.
4. Guide the disc slowly and evenly along the planned line of cut.

cleaninG and mainTenance

Danger of electric shock!
Before cleaning, always remove the plug from the mains socket.
8
71778 manual.indd 8
Great danger of injury!
Dangerous mains voltage!
31-12-10 15:43